APPENDIX D Dialogic GammaFax Support
This appendix provides detailed information on the Faximum Messaging Server's support for Dialogic GammaFax boards.
At the time this version of the Faximum Messaging Server was developed, Dialogic/GammaLink had only released support for their fax boards on SCO OpenServer 5 and not for SCO UnixWare 7.
Therefore if you wish to use FMS with Dialogic/GammaLink fax boards you will need to be running SCO OpenServer 5. If you need support for SCO UnixWare 7, please contact Faximum Software for the latest information.
This version of the Faximum Messaging Server was built using the GammaLink Developers Kit for UNIX (GDK/UNIX) Version 1.0.5e for SCO OpenServer 5.
According to the information provided to Faximum by Dialogic/Gammalink, the GDK supports the following fax boards:
Before trying to configure the Faximum Messaging Server you will need to install the GDK 1.0.5e device drivers (available from Dialogic) and configure the drivers to work with your GammaLink fax boards. Please refer to the documentation from Dialogic.
The gfax.cfg File
The configuration of the Dialogic/GammaLink boards is critical and is covered in the documentation provided by Dialogic/GammaLink. For the information of customers using the CPi/100 board (the board used by Faximum Software to test its software), here is the /usr/gl/fax/gfax.cfg file used by us:
chassis 1
buffers 0
numchan 1
controlt 60
queuet 45
updatet 300
channel 1 0 GFAX1.01
country 1 1
init 1
boardtype 1 0x06c5
load 1 /usr/gl/fax/bin/gfxcx.bin
csid 1 GammaFax 1
gfxecm 1 1 1
gfccontrol 1 36 0
gfxshutdown 1 2
We would strongly recommend your contacting Faximum Technical Support (support@faximum.com) prior to configuring FMS to work with your Dialogic GammaLink boards to see if there are any relevant TechNotes or new information that has become available after this manual was prepared.
To configure FMS to use a port on a GammaLink fax board you will need to create or edit the appropriate fax-line file (see "Fax Line File(s)" on page 113). If you also wish to receive faxes you will need to obtain a new start-up script from Faximum to replace the /etc/init.d/fms file so that the faxlisten program (which is used to manage fax reception on GammaLink boards) is properly started when the system is booted.
© 2000 Faximum Software Inc.